In terms of the design criteria for ergonomics the drill handle utilises the recommended power grip and is at 79 degrees to the housing. The handle itself has been developed over and over again until a comfortable shape was created within the restraints given by the tech pack. I used the two screw bosses on the handle to frame where the fingers should sit, so they wouldn’t get in the way. The handle meets all of the ergonomic requirements in terms of width and length, and uses the pinch grip for the trigger.

One of the design criteria in terms of ergonomics is that the drill should be made of non-slip material. As the outer housing is made from pressed stainless steel I’ve used the the two internal plastic frames as grip points. The frames show their edges along the part line and on both sides along the gripping area of the handle there is a jagged teeth pattern to act as grip. Subtle but effective.
