DESIGN FOR MANUFACTURE


A major component of the design criteria is that the design is detailed for manufacture, the following page explains these design for manufacture details.

The Stelton ipod dock design can be divided up into 3 basic assemblies; an internal plastic housing, an external stainless housing, and a plastic inlay. The internal plastic housing holds all the pcb’s and one of the speakers, the plastic inlay surrounds this internal housing and the other of the speakers. The stainless external housing surrounds both the plastic assemblies. The six plastic feet act as fixing points between the assemblies.

The most complex of these 3 basic assemblies is the internal plastic housing (below), the assembly that houses all the pcb's, one of the speakers and the interaction assemblies.

Interaction assemblies

Both the ipod reciever housing assembly and the botton housing assembly clip into the internal plastic housing to make it easier and cheaper to assemble. Also it allows a flush finish which is required for the sliding functionality of the ipod dock.

Wiring layout

Here you can see how the pcb’s are layed out so that the wiring can work with the sliding function. Enough room is left at the back so that the wiring between the main pcb and the ipod reciever/button pcb’s can fit. Also enough cable to the stationary speaker has to be left so that the cable can reach whilst it in full open position.

Remote assembly

I wanted to achieve a clean and simple look for the Stelton remote so I eliminated the need for any joinery. The plastic remote insert has flexible ends that can be flexed in and then pushed through the stainless steel external housing and then clips back out when it is all the way through, holding it in place. The battery insert clips into this on the other end and can only be released when pinching the ends of the plastic remote insert again.

Above you can see how the process of releasing the battery insert, first you squeeze the ends of the plastic remote insert then simply slide the battery insert out.

click the assembly and follow the links to see bill of materials

Above you can see the overall exploded view of the ipod dock, it shows how the 2 plastic assemblies at either end come together using fixing screws from the back. Then the speaker covers are attached from the bottom and both assemblies slide inside the stainless steel external housing fixed by screws coming up through the bottom.


DFM summary

Excluding the two extruded stainless steel components (external housing and remote external housing) all the non-technical components were injection moulded using ABS. I chose to use only two materials and only two processes because i wanted to keep control as much as possible over the Stelton ideal of 2 contrasting elements, wether it be colour or material. Also using only two processes and materials cuts down on the cost of manufacturing the design whilst also making it more environmentally friendly (less types of materials, easier to recycle).

This free website was made using Yola.

No HTML skills required. Build your website in minutes.

Go to www.yola.com and sign up today!

Make a free website with Yola